catchlasas.blogg.se

1. #Cisco wlc integration guide code#
2. #Cisco wlc integration guide windows 7#
3. #Cisco wlc integration guide windows#

connect AP with this port after configuring the following. Wherever you want an wireless AP, configure a port with same vlan. Note: This port will be connecting with Cisco 1142 AP. Switch(config)#switchport trunk encapsulation dot1qĬreate VLAN in a switch (Example: Cisco 2960G)

Switch(config)#interface gigabitethernet 6/11 Note: This trunk will be connecting with Cisco WLC 5500 using CAT6 or Fibre optic. Switch(config-if)#ip helper-address 10.10.9.4 Switch(config-if)#Description Wireless Network

Note: Entire wireless infrastructure will be placed in this VLAN.

To verify, click on the scope options in the newly created DHCP scope, you will see 241 Cisco Wireless AP or what you mentioned in Description.Īdd a new VLAN in core switch(example: Cisco 4506) or 元 switch: Now the DHCP option 43 (241 Cisco Wireless AP) that is made available for a newly created DHCP scope for Cisco.ġ0. This DHCP option is IP address, the DHCP server sends the option 43 as well as to the LAPs. Click Apply.ĩ.Once you complete this step, the DHCP Option 43 is configured. Check the 241 Option 43 check box, and then enter each WLC management interface IP address(s) Example: 10.10.10.2. Choose the Vendor Class you previously defined. Right-click Scope Options, and choose Configure Options.Ĩ.Click the Advanced tab. Now, the vendor specific information must be defined for the AP DHCP scope. Click OK.ħ.The Vendor Class and sub-option are now programmed into the DHCP server. Enter a Description such as Wireless LAN Controller IP address.

#Cisco wlc integration guide code#

In the Code field, enter the sub-option code value 241 (0xf1). In the Name field, enter a string value, for example, Option 43. Right-click the DHCP Server Root, and then choose Set Predefined Options.ĥ.Choose the newly created Vendor Option Class in the Option Class field, and then click Add.Ħ.The Option Type box appears. Then, click Close on the DHCP Vendor Classes window.Ĥ.Add an entry for the WLAN controller sub-type as a pre-defined option configured for the Vendor Class. Click the ASCII Section and enter the appropriate string value such as “Cisco AP c1142” (without inverted coma) for the Vendor Class Identifier. Enter a value for the Display Name field, for example, “Cisco Aironet c1142 AP”, and an appropriate description such as “Vendor Class identifier for Cisco Aironet c1142 AP”. Click Add.ģ.A New Class configuration box appears. Right-click the DHCP root, and then choose Define Vendor Classes.Ģ.The DHCP Vendor Classes utility appears.

#Cisco wlc integration guide windows#

Note: Follow these steps for newly added DHCP scope mentioned in assumptions.ġ.In order to configure these options in the Windows DHCP server, open the DHCP Server Administration Tool or MMC.

#Cisco wlc integration guide windows 7#